djiuser_WmDiHr2
New
United States
Offline
|
DroneFlying Posted at 2017-10-16 10:10
I looked at the DAT file and it is a valid one, but it doesn't quite seem to match the description you provided, so is it possible that this file is from a different flight?
It actually shows three separate flights, all in approximately the same location. The first one appears to have ended as a result of some sort of downward sensor blockage (debris in the sensor or landing gear extensions or a tracking device attached?) , and in the other two you triggered RTH and it appears to have landed normally. I didn't see any indication of a crash in any of them and there doesn't appear to be a tree near where the Mavic flew, so I'm not sure what to tell you based on this particular DAT file.
Thank you for looking at these log files.
So, I got up this morning, decided that for $1,000 I should not have to start out troubleshooting, went back to Fry's Electronics, and asked for a replacement unit. After considerable discussion, they did swap it out.
So, with another bird in hand, I charged everything up, updated the firmware, installed some prop protectors (after yesterdays experience) and went out for a test spin. Things did not go well.
After a careful lift-off, I tooled around an area trying to gauge the effect of the prop guards. Suddently the mavic started climbing without control input. At 325' I semi-paniced, hjit the stop button to regain control, and started to bring it down. The controls acted strangely, and I had trouble landing. RTH did not work too well either.
I am becoming despondent.
This is my THJRD unit. What am, I doing wrong?
|
|