I was flying/filming at about 10' near a tree when a strong gust of wind actually was able to push the Inspire 1 over and I instinctively tried to steer it back but sent it right into the tree as the Inspire was facing me and so went the opposite direction.  

The Inspire fought it's way down and hit the grassy area below and the camera/gimbal was jarred loose.  I was able to put it back on (the rubber shock absorbers squeezed back in).  

While the camera tests well, the motors and everything acts good, it appears that a screw or bolt in the mid section of the metal plate fell out (or maybe there is just a threaded hole in the center for something else).

Anyway, it is not like you can just go and find a picture or video showing the under carriage of the Inspire 1 anywhere to compare how it is supposed to look (I know as I have checked).

Would someone please post a picture of the underside of the Inspire so that I am able to compare what is correct with what I have?

Thanking you in advance.

I was flying/filming at about 10' near a tree when a strong gust of wind actually was able to push the Inspire 1 over and I instinctively tried to steer it back but sent it right into the tree as the Inspire was facing me and so went the opposite direction.  

The Inspire fought it's way down and hit the grassy area below and the camera/gimbal was jarred loose.  I was able to put it back on (the rubber shock absorbers squeezed back in).  

While the camera tests well, the motors and everything acts good, it appears that a screw or bolt in the mid section of the metal plate fell out (or maybe there is just a threaded hole in the center for something else).

Anyway, it is not like you can just go and find a picture or video showing the under carriage of the Inspire 1 anywhere to compare how it is supposed to look (I know as I have checked).

Would someone please post a picture of the underside of the Inspire so that I am able to compare what is correct with what I have?

Thanking you in advance.