Hi I tried everything but still end with the same issue, Lightbridge only giving me 8 channels per radio in this case the futaba 14SG

what I'm doing wrong? if I connect two radios and I can get 16 channels 8 per Remote. but can't find a way to add more than 8 channels to a single Transmitter. please any help is apreciatted

You need to change the CH Mode to 12 or 16 channels.
you can do it by following steps:
1. Select System on the controller
2. select Trainer
3. Scroll all the way until you find CH Mode on the bottom of  the list.

Any clue now with the new firmware and 8 channels I have very low signal strength and range and video now is half of what it was before new upgrade? I now have video loss as well as half the range as before??

archer02 Posted at 2015-5-26 10:02
Any clue now with the new firmware and 8 channels I have very low signal strength and range and vide ...

same as the I1.
Downgraded.

Hello. Have same problem. Change 8CH to 16CH in TRAINER, but with this setting any channel not work. It work only when set 8CH

Not sue if you meant you were using to receivers in Dual mode ?The 14SG comes with a single 8 channel receiver if you want to get 14 channels to work on your transmitter you will have to purchase a second receiver and use dual mode in your TX .Click on link below

This may be a better link ...hope this helps

With Lightbridge futaba reciever not used. Futaba connect to LB ground unit through trainer port.

DJI-Tenna Posted at 2014-10-21 21:43
You need to change the CH Mode to 12 or 16 channels.
you can do it by following steps:
1. Select System on the controller

Nice Info... thx a lot  !!

Grettings from Austria