Hello,
     I noticed today (when upgrading our M600 Pro's) that the new version fo DJIA2, shows the firmware status as 'Refresh' as opposed to 'Current'. At first I was not sure the upgrade had completed successfully so I did it again, same display. Is this now the normal display when you check firmware in the Assistant, or did I miss something?

Thanks

Could you post a screenshot of DJI Assistant 2 for better assistance?

Hello,
     Here are the 'ScreenShots' you requested.

Thanks.

Here are the Screen Shots.

Thanks.

Screen Shot

I've been getting the same thing to "REFRESH"