ThisMonkey
New
United Kingdom
Offline
|
I have recently got a P3A and have flown a few times before the update without any problems, i just turnws on my RC, my AC and launchws the app and I was straight into camera view and was able to take off. Now I have updated to FW v1.11.0020 and everything has, well....stopped. So a quick run down of what happened/is happening;
I updated the firmware on my aircraft using the SD card which i connected to my pc through an SD to USB adapter. The update ran on the AC, showed all signs of a complete update and the txt file left on there said it was a success -LOVELY
Then I put the same sd card into the usb adapter and into my controller and there were a series of beeps and my controller light has gone CYANnot BLUE, not GREEN, but CYAN
After this I can't connect my app to the controller or the controller to the aircraft. The RC doesn't make a beep on start up but does beep three times in a descending tone on power off.
When i turn my AC on it beeps like the start up then the yellow lights are flashing with the red lights at the front still on. I do assume that there is some sort of problem with the controller but i can't find anything that helps my situation. I have noticed a few people talking about the new update v1.11.30 but I don't know if that is 'a thing' or not yet
Any help would be massively appreciated guys, I've been grounded for over a week and this migraine isn't easing... |
|