bruce.sidlinger
lvl.3
Flight distance : 219183 ft
United States
Offline
|
I have an Inspire 2, X5S, Cendence, and the most-expensive flavor of CrystalSky. I have many other DJI multirotor systems but this is my first on the above configuration.
My focus knob has a huge dead band (I can tell because Focus Assist drops out) and then when I finally find the active zone of the control it shifts from closest to infinity so rapidly it’s more like a binary near/far switch than a knob.
I tried to set up the I2 controller as a slave but couldn’t get the right wheel to do anything so I temporarily gave up on that.
The biggest issue is that the CrystaySky (on the Cendence in single-controller mode) gets terrifyingly behind the aircraft. I would move the gimbal pitch, for example, and then maybe 20 seconds later see the gimbal scale appear in GO 4 and slowly replay my movements. The same with the shutter release and the record button, I’d wait 15 seconds for feedback after taking a picture.
I have all the latest versions (as of December 21.)
The slow response makes me almost afraid to fly the I2, and certainly makes it unusable for photography or videography.
I turned off video caching, and reset the camera to defaults. Basically, everything is at new-product defaults.
If any of this sounds familiar, well, misery loves company. |
|