I have a DJI S900 with an A2 controller. From the A2 assistant software you can see that the futaba 14SGH controller is linked to the A2 controller. There is also a green LED light on the drone. However when I take the drone off of the A2 assistant there is no actuation in the propellers. The drone passes the propeller test
I had the green blinking led and it turned out to be bad...replaced it and everything worked...don’t know if that’s your issue but thought I’d let you know
DennisMurry08 Posted at 2017-11-14 09:56
I had the green blinking led and it turned out to be bad...replaced it and everything worked...don’t know if that’s your issue but thought I’d let you know
what was bad? the hardware or was it a software issue?
Both of the Remote control sticks should be toggled to the lower left corner during Channel Calibration. The slider of ATRU four channels should be toggled on the left side. If there's any different, please click Channel Reverse.