Please select Into the mobile phone version | Continue to access the computer ver.
DJI S900 linked to A2 controller but no actuation
646 5 2017-11-13
Uploading and Loding Picture ...(0/1)
o(^-^)o
ariel.baron
lvl.1

United States
Offline

Hello,

I have a DJI S900 with an A2 controller. From the A2 assistant software you can see that the futaba 14SGH controller is linked to the A2 controller. There is also a green LED light on the drone. However when I take the drone off of the A2 assistant there is no actuation in the propellers. The drone passes the propeller test

2017-11-13
Use props
DennisMurry08
Captain
Flight distance : 5442736 ft
  • >>>
United States
Offline

I had the green blinking led and it turned out to be bad...replaced it and everything worked...don’t know if that’s your issue but thought I’d let you know
2017-11-14
Use props
ariel.baron
lvl.1

United States
Offline

DennisMurry08 Posted at 2017-11-14 09:56
I had the green blinking led and it turned out to be bad...replaced it and everything worked...don’t know if that’s your issue but thought I’d let you know

what was bad? the hardware or was it a software issue?
2017-11-14
Use props
ariel.baron
lvl.1

United States
Offline

Hi, It turned out that the magnetometer calibration needed to be done or else it wouldn't fly
2017-11-15
Use props
DennisMurry08
Captain
Flight distance : 5442736 ft
  • >>>
United States
Offline

ariel.baron Posted at 2017-11-15 08:37
Hi, It turned out that the magnetometer calibration needed to be done or else it wouldn't fly

The old GPS dance...good, doesn’t cost anything...
2017-11-15
Use props
DJI Susan
Administrator

Online

Both of the Remote control sticks should be toggled to the lower left corner during Channel Calibration. The slider of ATRU four channels should be toggled on the left side. If there's any different, please click Channel Reverse.
2017-11-19
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules