Hello,

I am trying to find a case which will fit the I2 when in landing mode and also with props installed. Does anyone know of such a case?

If not, can someone take the time and take measurements with the props installed in various directions? See photo examples below. I am looking for wides dimensions (looking at the aircraft top-down). Goal is to see what case would be able to accept the bird with props installed.

Thanks in advance to whomever is willing to take the time and get these measurements.

i dont have an I2 but i do have a I1 with a GPC landing mode case. and its hugh. i can only imagine the size to keep the props attached.

case i have

have you thought about getting the carbon fiber folding props for the I2 instead? they pricey but prob cheaper than a case youd need big enough

carbon fiber folding props

I'm assuming you don't have time to do pre-flight tests either?

We don't suggest to store the drone with the propellers attaching, they are fragile and need to be taken good care of.
For the dimensions you requested, we will give you later, please allow us some time. Thanks for the patience.

Mark Guille Posted at 2017-11-14 11:31
I'm assuming you don't have time to do pre-flight tests either?

This has nothing to do with Pre-Flights or speediness of deployment. Instead, it has everything to do with wear and tear. We have found in our operations, the less we have to remove equipment, the less chance of a failure. Also, after removing props a few thousand times, there will be some wear and tear where if we are able to keep props installed, we will have to worry much less about mid-flight failures.

DJI Mindy Posted at 2017-11-15 01:19
We don't suggest to store the drone with the propellers attaching, they are fragile and need to be taken good care of.
For the dimensions you requested, we will give you later, please allow us some time. Thanks for the patience.

Thanks Mindy. We look forward to hearing back from you.

ehcropydoc Posted at 2017-11-15 09:13
Thanks Mindy. We look forward to hearing back from you.

Here are the dimensions you requested.
Please let us know if you have further query.

ehcropydoc Posted at 2017-11-15 09:12
This has nothing to do with Pre-Flights or speediness of deployment. Instead, it has everything to do with wear and tear. We have found in our operations, the less we have to remove equipment, the less chance of a failure. Also, after removing props a few thousand times, there will be some wear and tear where if we are able to keep props installed, we will have to worry much less about mid-flight failures.

Just curious, why couldn't you take your measurements from your Inspire?

Rodger8 Posted at 2017-11-19 04:33
Just curious, why couldn't you take your measurements from your Inspire?

We do not have an Inspire 2 at the moment. Very close to purchasing one however.

ehcropydoc Posted at 2017-11-19 09:14
We do not have an Inspire 2 at the moment. Very close to purchasing one however.

OK, that makes sense. Go for it, you won't look back.