Please select Into the mobile phone version | Continue to access the computer ver.
Lighbridge Camera Mode Switch problem
858 2 2015-4-11
Uploading and Loding Picture ...(0/1)
o(^-^)o
richardhuison
lvl.3
Flight distance : 54455 ft

United Kingdom
Offline

on mapping a 3 position switch on my Futaba 14SG for the camera Mode. The LB software shows the switch moving between "H free" "Reset" "H Trace" but the gimbal does act in the correct manor. It will reset but only in the "H Trace" position.

I've followed this post but can't figure out the issue

2015-4-11
Use props
Tahoe_Ed
Administrator
Flight distance : 2605 ft
  • >>>
United States
Offline

My question is what is it not doing?  Have you power cycle the ground unit?  Did you check the Zen Assistant?
2015-4-11
Use props
richardhuison
lvl.3
Flight distance : 54455 ft

United Kingdom
Offline

I did power cycle the LB on the Ground Unit and i checked the Gimbal set up and everything is behaving as it should in the software. but this does not translate to the gimabl.
I took some videos to show the problem

http://youtu.be/rptfvb31CSg
http://youtu.be/JVEa-XwhndA
http://youtu.be/NHP2Eh-nUbA
2015-4-12
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules