on mapping a 3 position switch on my Futaba 14SG for the camera Mode. The LB software shows the switch moving between "H free" "Reset" "H Trace" but the gimbal does act in the correct manor. It will reset but only in the "H Trace" position.

I've followed this post but can't figure out the issue

My question is what is it not doing?  Have you power cycle the ground unit?  Did you check the Zen Assistant?

I did power cycle the LB on the Ground Unit and i checked the Gimbal set up and everything is behaving as it should in the software. but this does not translate to the gimabl.
I took some videos to show the problem

http://youtu.be/rptfvb31CSg
http://youtu.be/JVEa-XwhndA
http://youtu.be/NHP2Eh-nUbA