I have an Inspire 1 that I've been using an Inspak backpack for, which allows you to keep the gimbal attached. Been using it with the Zenmuse X3 mounted for a while until just recently I pick up a barely used Zenmuse Z3 (well basically stole it with how cheap it was). well unfortunately I didnt want the Z3 mounted and not secured somehow, so been caring it seperately. Until recently just came across a sight selling a gimbal lock for the Z3 http://www.aero3d.co.uk/ purchased one and it fits perfectly. Only thing I did was add 4 layers of electical tap to the back by the motor to make it a tad snugger fit. Had to slighty mod the case too an cut a small corner out so the Z3 would go down into the case properly. The gimbal lock is made Semi flexable, so its soft and rubbery