There's a few new functions on the recently released Cendence/Crystal Sky hardware. There is, as of yet, no descriptive manual of the control functions.
What does "Get Gimbal Control" mean?

When you have a slave remote connected its supposed to request control of the gimbal but it doesn't work

Hi, Raven, MadFrenchie is right, when you set Master and Slave RC, this button is used to obtain gimbal control quickly.

MadFrenchie Posted at 2017-12-3 18:51
When you have a slave remote connected its supposed to request control of the gimbal but it doesn't work

I've tested this button, it works, may I know if you have updated your Cendence to the latest version?

DJI Mindy Posted at 2017-12-4 03:44
I've tested this button, it works, may I know if you have updated your Cendence to the latest version?

Ahhhh, IC...thanx

DJI Mindy Posted at 2017-12-4 03:44
I've tested this button, it works, may I know if you have updated your Cendence to the latest version?

Yes the controller is updated to the newest firmware.

The pilot remote is a Cendence, and the Slave remote is a standard Inspire 2 remote.

When the slave has control of the gimbal and the master presses the "Get Gimbal Control" button nothing happens.

I've tested it many times.

MadFrenchie Posted at 2017-12-5 04:53
Yes the controller is updated to the newest firmware.

The pilot remote is a Cendence, and the Slave remote is a standard Inspire 2 remote.

Hello, Sir, I tested our Cendence and it works flawlessly.
If the problem do persists, any chance to take a video about the issue including firmware version? I will transfer it to our developers for test and analysis. Appreciate your time.