fans2d5fc9c0 lvl.1 United States Online

11# HELP!  My gimbal is flashing green!!! Does not initialize, just blinks green. Background - I bought this Ph3 ADV used after the owner crashed it - the yaw arm was broken and the roll arm was bent -- I put a new ribbon cable and new arms on - but NOTHING on start up - camera never moves -- I did check the two gray cables and they seem to seat properly -- have yet to buy an SD card - so slot is empty - any leads would be very much appreciated! Status on iPhone says gimbal disconnected

When you say "two gray cables", did you check them for breaks, or nicks?  Also, check the board on top of gimbal.

yes - I wrung out the smaller cable and it check good across all connections - the larger cable "appears" to be nick free -- I used a magnifying glass on both sides of the board above the gimbal but did not see any damage

Hello Sir, I'm sorry to hear the issue. To ensure the performance, I'd suggest to send it in for fully repair: http://www.dji.com/support