Hello,
I am having problems with the up and down motor on my p3 standard gimbal. I power up the drone and it all spins around fine, I go to move the camera up and down but it moves a little and gets stuck. I bought the drone new from eBay less than 3 months ago and it worked fine until now. I have not crashed it, I cannot think of anything that would have caused this. If anyone has any insight at all into this matter, anything is appreciated. Thanks !

Hey, have you got any error message in the APP? Please do a gimbal calibration, see if it can be finished successfully. Besides, please try to reset the gimbal settings (Gimbal Settings--Advanced Settings--Reset Settings). If it persists, please post a video about this issue for better assistance.

Check for ribbon interferance. Mine came unglued and gets in the way when moving lens up and down

Were you take off and land your P3S on dusty or sand ground. May be you get a little bit sand core in to the pitch motor of the gimbal.
If it ´s so then take a blower and blow that out of the motor.

I'm with fans check ribbon cable for interference.