Hello.
I bought a new P3 SE. After the third switch on, the LEDs on RC and AC are red. RE-linking in DJI Go did not help, sayd that successfully, but the situation does not change.
Help.
Hi sir, so the app said linking succeed but they don't link, right? Please try to restart the drone and try again, please kindly follow the tutorial Nebuchadnezzar posted on 3#.
If it doesn't help, please check if there is a need to update the firmware, update and try to link again. See if it helps. Looking forward to your update.
Link under RC&AC is back
I think this happened because firmware upgrade automaticly. Firmware upgraded on 1.5.40.
Faced a new problem. The range was 500 meters, instead of the declared 4000 meters. WTF??
u3max Posted at 2017-12-13 18:05
Link under RC&AC is back
I think this happened because firmware upgrade automaticly. Firmware upgraded on 1.5.40.
Faced a new problem. The range was 500 meters, instead of the declared 4000 meters. WTF??
Hey there, our drone followed the local regulations. The flight distance of FCC Compliant is 4km and CE Compliant is 500m(Unobstructed, free of interference), please kindly note.
hello, I have the same problem ... Impossible to link the drone with the control ... I tried to vinvulate it according to the instruction manual without success ... Also through the application dji go ... always without success
This has happened after updating the aircraft to the latest firmware 1.5.40
The control LED and the aircraft link LED remain in red
yo usaria la version de la aplicacion DJI Go ó DJI go 4 que funcionaba bien .... a mi me paso algo parecido ... son problema de conflicto entre APP y FW.
Yo uso Un Phantom 3 SE
fans08119e75 Posted at 2017-12-14 04:17
Tengo instalada la DJI GO 3.1.23 en IOS...que yo sepa no hay manera de instalar una mas antigua....También uso un 3 SE
Tengo también un PH4 Pro y estas cosas no pasan, pero claro no se puede comparar un aparato con otro.
Ios or Android?
For android you can look for a previous app version on www.apk4fun.com