Altitude Photos
lvl.3
United Kingdom
Offline
|
There are still too many bugs on the CrystalSky that need fixing. I have multiple CS screens and this happens on them all.
Bug 1:
When using a slave Lightbridge 2 controller on more than one aircraft you can not enter the PIN number to gain control. The keyboard covers the ‘OK’ button on the dialog entry box when you enter the pin and there is no way to close the keyboard. As a result you have to unplug the CS and in my case use an iPad instead to change the settings.
Bug 2:
If you switch the Lightbridge 2 controller off before switching off the CS, the CS typically crashes, freezes and becomes completely unresponsive.
Bug 3:
The CS will randomly switch itself on when switched off.
Bug 4:
I have two M600’s, but the screens only work with one of them. The aircraft are both M600’s with identical firmware, identical A3 pros, identical gimbals and set ups, as well as running identical settings on both. An iPad will however work on both.
Bug 5:
If the M600 is not unlocked in the assistant software it can not be done on the CS, again I had to plug an iPad in to do this instead.
Bug 6:
The CS will not work through the wired connection on an Osmo, despite buying all of the correct cables and fitting them exactly as per the instructions, it will only work through the WiFi of the Osmo. As a result I have pointless unusable cables dangling around my hands that serve zero purpose.
I’m sure there is more, but these are the ones currently frustrating me the most.
|
|