Jlotu
lvl.1
Flight distance : 19009 ft
United States
Offline
|
We are getting terrible video signal performance on both of our M600s both with Light bridge 2. In every condition, on shore, off shore, middle of an open field, urban environment, in the US and in Trinidad, almost as soon as we take off, the video feed starts to lag massively and becomes unusable. I can stand right next to the pilot and his video feed is perfect. On the slave controller, I will have full signal bars on both control and HD, all telemetry updates and displays in perfect sync with the pilots screen. I can control the gimbal with no problems, but I have to look over the pilots shoulder to use his screen. We normally use DJI Go app on iPad minis but the same happens in any app we use and on our Crystalsky monitors as well. All firmware and app versions are up to date. What are the options to fix this? I was told by a DJI rep at his years Airworks in Denver that the video and data feed on the slave controller only comes from the master controller rather than directly from the M600. If his is the case, if the slave controller is inches away from the master controller, why does the video on the slave perform as if it’s 50 miles away? |
|