BBB
lvl.1
Flight distance : 94101 ft
United States
Offline
|
So far I have wasted around 10 hours attempting to update the firmware in the DJI Goggles RE. The original problem was, when in Analog Drone Racing Mode, the image cropped the top and bottom of the actual camera image, i.e., made 16:9 out of 4:3 aspect ratio by cropping.
After infinite attempts to update the firmware to v01.00.0100, I finally got one successful outcome. I briefly tried the goggles in analog mode and was able to see a complete image on frequency 5925.
Yesterday I attempted to fly my analog racing drones using the goggles. I discovered that the goggles would not tune to 5925, seemed to limit upper channel to 5850. So I reset Tx to 5740 and tried again. The goggles failed to recognize this freq either and had no image.
Last night I attempted to "Refresh" v01.00.0100 using DJI Assistant 2 v1.18. No joy, just repeated failures.
Unless I just have a defective set of goggles, I cannot be the only one having these issues.
I understand that DJI has a reputation for horrible customer service. I don't even know where to begin.
Any info/suggestions would be appreciated.
Thank you, Bob.
|
|