I just got a new Osmo+, set it up, activated, ran the new firmware update.  It will not connect, for longer than a minute.  I have repeatedly tried to run through the tutorial and it disconnects immediately.  The picture is black, all the information is still on around it.  I have tried to the trigger reset, and the indicator light either flashes red/green or is yellow.  

Hi, OESInferno, after firmware updating, did you delete or format the SD card?
Please remove the SD card to see if the image transmission will recover.
Thanks.

I have the same problem.  Amazingly frustrating.  Have spent hours trying to figure this out.