grounded62
lvl.1
United Kingdom
Offline
|
Hi
I bought a new Inspire 1 from a company in London.
The kit was sent to me direct from America.
I have a new tablet with the dji go app installed successfully but even though I am following the set up instructions, the controller won't link to the aircraft.
I turn on the RC, then start the dji go app, then turn on the aircraft ..nothing happens.
Same sequence then press the linking button on the aircraft..nothing happens.
The red light remains on the controller and the aircraft has a blue light.
The aircraft, obviously is still in travel mode.
As you can imagine, this is upsetting and frustrating as I keep reading that the aircraft and controller must be linked before any adjustments can be made..
Can anyone help.
I have read a lot about this problem occuring after firmware updates but this doesn't apply because the aircraft and controller came as a sealed package brand new .
|
|