I have an issue using the dual camera payloads and switching between each camera. In this example, I am using a M210 / Cendence / CrystalSky / X4s and XT V2

When I first connect, the X4s live view is the primary camera feed. If I switch to the XT, this appears full-screen and the X4s feed reduces. Fine.

If I then want to switch back to the X4s as the primary image, it never restores to the full screen size. Yes, I do have latest frimwares and XT is mounted on the left and X4s as you look at the M210 front onwards.


Please help!

Same issue for me. Were you able to get it figured out yet?

dronie326 Posted at 2018-1-12 08:47
Same issue for me. Were you able to get it figured out yet?
https://youtu.be/mHY87QTzgls

Firmware issue with the Z30 and or XT.  The last firmware mentioned fixing issues with the Z30.  Are you positive Firmware update took?

rkeihn Posted at 2018-1-13 17:34
Firmware issue with the Z30 and or XT.  The last firmware mentioned fixing issues with the Z30.  Are you positive Firmware update took?

I haven't updated the Z30 firmware  back since the last firmware release in September. I believe this just started happening after the latest M200 firmware. Everything worked normally before that. I'll try reloading it tomorrow and see if that helps any.

look at the picture

The gimbal connector configuration is not the issue. They are mounted on the correct connectors.

Has anybody found a solution to this problem?