hi I have upgraded my vsion 2 with a h33d gimbal and gopro.
everthing works ok except i
only get about 50meters of range before the range is lost.
when i dosconnect the 8pin plug that is fitted to the interference board
the range issue is gone.
any advice?

thanks

Have you moved the position of the board?
Theres a youtube video on this.

mixstreme Posted at 2014-10-26 22:33
Have you moved the position of the board?
Theres a youtube video on this.

if you mean the mother board in the drone? no.
I just added the interference board.
can you point me in the direction of the youtube clip?

cheers again

steve@sanwell.c Posted at 2014-10-27 06:31
if you mean the mother board in the drone? no.
I just added the interference board.
can you point  ...

Hi,  No, I meant the anti interference board to be relocated....  



Worth having a search around for the best results but if it works great when not used, don't use it.

thanks for that, I haven't yet moved the interference board, however I did disconnect it
but this made it worse.
I was thinking that the drone/remote are both 5.8 and so is the fpv transmitter set up-perhaps
this is the problem? maybe I should swap out the drone and remote for the 2.4 set?
in any case in the mean time I will relocate the interference board outside the drone as suggested.

cheers

steve@sanwell.c Posted at 2014-10-31 06:28
thanks for that, I haven't yet moved the interference board, however I did disconnect it
but this m ...

Could you please check if the gopro wifi is on? If yes, please turn it off.

Yes it is off