Please select Into the mobile phone version | Continue to access the computer ver.
Epson Moverio BT-300 Upgraded to R1.4.0 problem
820 5 2018-1-16
Uploading and Loding Picture ...(0/1)
o(^-^)o
fans63eb6c3c
Second Officer
  • >>>
Australia
Offline

After I upgraded to R1.4.0.I noticed that both Spark and Mavic cannot be connected any more.
Both birds showed disconnect in the DJIGo4 app.

Anybody had the same problem using BT-300 version R1.4.0?

Thanks



2018-1-16
Use props
lannes
Captain
Flight distance : 4465 ft
  • >>>
Australia
Offline

A few things to try

1) try another OTG cable and try the different ports on the Mavic controller (left hand side and bottom)
2) The order in which you start up could be the problem -  I normally go , AC on, open the DJI Go 4 app, to the AC selection page. RC on
The connection of the RC and AC should trigger the auto selection of the AC
3) Are you getting a connection between the RC and AC, check moving the left control stick from left to right, the camera should move in response.
You might want to re-link the AC and RC , as the connection could be spotty
4) try out another tablet and phone e.g IOS


2018-1-19
Use props
fans63eb6c3c
Second Officer
  • >>>
Australia
Offline

lannes Posted at 2018-1-19 20:02
A few of things

1) try another OTG cable and try the different ports on the Mavic controller (left hand side and bottom)

Thanks lannes, I found it very useful and followed to what you instructed and got them both connected.
Thanks once’s again.
2018-1-19
Use props
lannes
Captain
Flight distance : 4465 ft
  • >>>
Australia
Offline

fans63eb6c3c Posted at 2018-1-19 21:19
Thanks lannes, I found it very useful and followed to what you instructed and got them both connected.
Thanks once’s again.

Great news, what was actually the problem
2018-1-19
Use props
fans63eb6c3c
Second Officer
  • >>>
Australia
Offline

lannes Posted at 2018-1-19 23:44
Great news, what was actually the problem

Good morning lanes, I think the OTG cable I bought is of bad quality that caused the problems.
Thanks for your concern.
2018-1-20
Use props
EpsonMoverio
lvl.2

United States
Offline

Glad you got it sorted out.
2018-1-24
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules