Well, the upgrade to 1.2.1.0 seems to have bricked by 2nd remote control. After successfully updating my Inspire, Master remote, and batteries, I went to upgrade my slave remote.

It began normally, but unlike my master, it just went on beeping for over an hour. I shut it down. No .txt. file. Now, I can boot it up and the light is purple, buttons beep, like everythign is normal, but it won't connect to my tablet anymore, and it won't try upgrading again.

I've tried different, freshly formatted USB cards and even connecting to the gimbal... Nothing will let it begin the upgrade again... <Sigh!>

Anyone else solved this particular issue?

Best,

Ben

Well, the upgrade to 1.2.1.0 seems to have bricked by 2nd remote control. After successfully updating my Inspire, Master remote, and batteries, I went to upgrade my slave remote.

It began normally, but unlike my master, it just went on beeping for over an hour. I shut it down. No .txt. file. Now, I can boot it up and the light is purple, buttons beep, like everythign is normal, but it won't connect to my tablet anymore, and it won't try upgrading again.

I've tried different, freshly formatted USB cards and even connecting to the gimbal... Nothing will let it begin the upgrade again... <Sigh!>

Anyone else solved this particular issue?

Best,

Ben