dylan
lvl.1
United States
Offline
|
I had a broken center support post and while I had the copter apart I upgraded the center frame support board with an after market anti-vibration board. Nothing electronic has changed - but now that I have the unit back together the BTU flashes green/yellow constantly. I tried everything and yesterday I thought I had fixed when it suddenly acted like normal - I was able to do a compass calibration, locked GPS and flew for ten minutes. Today, it's back to green/yellow flash.
I can go into compass calibration but it fails every time (red LED until I either try to calibrate again or reset power). Immediately on power up, it's flashes green and yellow. I've done an IMU calibration and reset every connection on board. I can't think of what else to try and I've changed nothing since the brief, successful flight yesterday.
|
|