I got a CNC gimbal that ended up being defected, but one thing I noticed is that I can use it without doing any soldering or the like. I just had to drill a small hole to let the second battery cable hang out so I could plug that into the gimbal.
Are there other cheaper gimbals that have been recommended to me that do this? For example I am interested in the Walkera G-2D gimbal or a Tarot T-2D V2. Is it possible just to use the battery plug to power these?

Thanks.

I use the Walkera G-2D gimbal on my Phantom after swapping out a CNC gimbal. The G-2D just uses the common JST connector for power.

Regards

Nidge