Hi, I have a problem with the remote control. When I start it, the red LED flashes and does not stop. In the instructions I saw that it means error. I can not connect to the drone because the combination of three keys does not work. A week ago everything worked. I tried to reset the controller by holding power 9 sec, but it did not work.

Red Flashes are followed by beeping sound? I had the same problem. I think you have to calibrate your sticks.

Sir, please try to calibrate the RC. Can you search the wifi of RC? You can try to holding power for 9 sec to connect the RC and then calibrate it in the app. Thanks for your support.

Unfortunately I can't search the WiFi of RC. Also after connecting to a computer, the RC is not detected.
The RC does not emit any sounds.

I too have the same problem..

fans89792df7 Posted at 2018-3-13 22:07
I too have the same problem..

In my case, the only solution was to send RC to the service

Now that i see this post, i notice that when i power on my RC, sometimes i see the red LED blinking, and change to green solid after its connected, i think before the LED would just stay on (red) and change to green after its connected to the Spark.

How should be the correct way? blinking or not?

Mine's starts with blinking red for about 5-10 seconds, then goes steady red, and then green when connected.

Have same problem after update firmware... tryed all, i know inside the rc, there is a reset also, but dont love to pill the rc apart

DJI Elektra Posted at 2018-2-5 20:33
Sir, please try to calibrate the RC. Can you search the wifi of RC? You can try to holding power for 9 sec to connect the RC and then calibrate it in the app. Thanks for your support.

Wont help, unfortanly...

fans98566db9 Posted at 2018-2-5 08:53
Red Flashes are followed by beeping sound? I had the same problem. I think you have to calibrate your sticks.

How would you do that, if not getting acces to the rc ?