Same issue here. I updated the firmware 2 months ago, flew a couple times flawlessly and then had a brake of about 3 weeks and the issue started.
I turn AC and Radio on then open DJI Go App, camera connects, AC warms up fine, AC lights blink green, app says "Ready to Go" yet..
ALL COMMANDS TIME OUT. Can't take off, can't set max altitude, can't change flight mode, can't set max distance. I've already tried:
- use different devices (Android and iOS); - clear app cache and data on different devices (Android and iOS); - reinstall the app on different devices (Android and iOS); - relink the radio.
This is the info on the "about" menu:
DJI Go App version: 1.5.40+ AC Firmware version: 3.1.11 Flight Controller Serial No.: N/A
At first I'd get no GPS signal even outdoors in wide open areas away from WiFi, radio antennas, electrical wires and etc. Then I opened the AC, disconnected the GPS module and started the AC without it. I expected it to throw some kind of "GPS module error" on the app, but it didn't change the behavior. Still goes on, still warms up, connects to the radio, to the app, image shows up fine, can control the gimbal angle, record and take pictures, but every control relative to the AC times out. I reassembled it and now I'm able to get GPS signal, but it still won't take any AC commands.
Is there any debugging software or debug logging mode I can use to get any clearer info on this?
|