Fnurga
lvl.1
Sweden
Offline
|
Hi,
I bought a P34K with broken gimbal to try to fix it.
When i bought it i knew that the roll motor and/or flat cable was defective. Flat cable is now replaced, but not motor.
My main question here is:
Should i get video feed even if the gimbal cannot calibrate at start and shuts of all stabiliziation?
Or do i possilby have another problem that causes to video feed? I get info about the tilt sensor to DJI GO.
Rotation and tilt motors seems fine and does the calibration dance at start.
I'm new to this, so just tell me if i need to provide more information!
Regards
|
|