Hi,

One of my antenna's of mc RC was broken, so I sent the RC for repair and I received a new RC.
When turning this one on, after a full charge, the RC makes a beeping sound and the red light is flashing.
I can't do anything in the Dji Go app.
How can I solve this ?

Thx for responding !

Best regards
Jan

TruGreen Posted at 2018-2-12 02:34
https://www.youtube.com/watch?v=kkynWM0Wh2U

Hi, it is not a linking problem, I can't even get connection between the app and the RC...

Hi Jan,

Without any connection between your RC and your device with DJI Go App, you won't be able to ascertain which version of firmware your RC has.

You may want to try downloading the Inspire 1 firmware v1.3.0.00 and unzip the .bin file into a USB thumb drive and insert it into the USB port of your RC to update it. See if this works.
Please refer to pages 7-9 in this How to Update Firmware v1.4 for instructions on how to upgrade RC using USB thumbdrive.

Henry

Jan you can also try to reset the RC.  * Turn on the controller, and make sure the aircraft is off.
* Press C1, C2, and shutter on the controller and then turn the controller off.
* Turn on both the aircraft and the controller and link the remote.

Henry M.Y. Posted at 2018-2-12 05:06
Hi Jan,

Without any connection between your RC and your device with DJI Go App, you won't be able to ascertain which version of firmware your RC has.

Hi Henry,
I tried it, but the upgrade doesn't start.
J

Tahoe_Ed Posted at 2018-2-12 06:20
Jan you can also try to reset the RC.  * Turn on the controller, and make sure the aircraft is off.
* Press C1, C2, and shutter on the controller and then turn the controller off.
* Turn on both the aircraft and the controller and link the remote.

Hi, I tried this several times, but the beeping and flashing red light just continuous...

Jan Mestdagh Posted at 2018-2-12 23:11
Hi Henry,
I tried it, but the upgrade doesn't start.
J

Hi Jan,

It seems that the flashing red light and continuous beeping indicate a remote control error. This will have to be repaired or replaced.

Henry

I agree with Henry.  Please go to dji.com/support and open a case for replacement/repair.  Sorry for the inconvenience.

Have you tried re-calibrating the sticks? I can't remember where it is in the Go app but mine was doing the same a while back, recalibrated and it's been fine ever since.

Mark

Hi Jan Mestdagh, as mentioned by Tahoe_Ed, please try the steps below again one by one and let us know.

1. Power on your remote controller. Once it started beeping and flashing red, move the controller sticks around as it may stop beeping by doing this.
2. Whether the remote controller stopped beeping or not from step 1, press the C1 button and hold, C2 button and hold, then shutter button and hold in sequence until you end up holding the three buttons together. While holding the three buttons, power off the remote controller and power it back on. Let go of the buttons after powering it back on.
3. If the remote controller LED light turns steady red, please proceed with manual linking by following the process in this video link -->

DJI Diana Posted at 2018-2-15 18:04
Hi Jan Mestdagh, as mentioned by Tahoe_Ed, please try the steps below again one by one and let us know.

1. Power on your remote controller. Once it started beeping and flashing red, move the controller sticks around as it may stop beeping by doing this.

Hi Diana,
Thank you for your post.
I tried it, but step 1 is already a problem, is does not stop beeping and flashing red.
Best regards
Jan

Any update?