djiuser_bgPHqFVacCA3
lvl.1
United States
Offline
|
From this thread shown here
https://forum.dji.com/thread-45147-1-1.html
User: Anton_Zda
Reported the solution to be here
Thanks for the feedback, guys! The problem for me was that after the app detected my drone (it detected the P3 Professional instead of the Advanced model), I was no longer able to swipe through different models within the app. The app basically locked onto the incorrect model and wouldn't let me adjust it after that point.
I was able to choose the "Camera" option as if I was about to connect to the drone, but the app would not fully connect (no data for the drone was displayed and the camera view was not present). After many hours of troubleshooting (including following the steps above), the solution was:
1. Open the DJI GO app.
2. After the app detects the drone (which was the wrong model in this case), choose the "Camera" option to try to connect to the bird. The app opened the flight mode view but again, no drone data was visible which means that the app was not fully connected to the drone.
3. Once the app opened the flight mode view, I went into the settings and under the controller tab, I found the option to "Link your controller".
After I chose this option, the problem was solved. The app started detecting the correct drone model and the app started displaying the drone data in the main flight mode view.
Hope this helps you out buddy!
|
|