When I start my Phantom 4 Pro I receive a message "Cannot detect camera lens.".  I can close out the message and continue the same as if you have been warned that you are in the warning zone of an airport.  What I have noticed is that even though the view on my ipad is fine and the camera is set to Auto the pictures are badly over exposed.  Can anyone help with this or these issues.

Hi there, what's the current version of the aircraft, controller, and APP? Please try to refresh the firmware to check whether it is misinformation. If no luck, please kindly offer the screenshots of About page and warning message for double check,  I'll forward to our engineers for review, thanks in advance!

Here are my current versions:
P4P  V01.05.0300
App  V4.2.4
Controller  V01.04.01.00

I have refreshed the P4P firmware to V01.05.0300, also tried down grading to  V01.04.0602.  When doing both of these refreshes everything goes fine until the update reaches 72% and the aircraft does an automatic reboot.  At this point the update fails for both versions.

My one year warenty is going to expire in a few days, do I need to do anything to make sure my aircraft is still covered?

fans74e4bd7d Posted at 2018-2-24 09:43
Here are my current versions:
P4P  V01.05.0300
App  V4.2.4

Thanks for getting back to us. I'm afriad that this can not be figured out remotely, please kindly start a case and send it in for diagnosis: https://www.dji.com/support

i have same problem with this.. is it hardware or software problem?