samflies
lvl.1
Flight distance : 4360 ft
New Zealand
Offline
|
Absolutely - thanks you for your help! This is in order
**Installed Go4 App on Samsung S7 and ran firmware update when prompted on startup. Stalled at 83
At this stage I was able to skip the firmware update and on two occasions it let me get the aircraft airborn in my living room for a few seconds. I was able to navigate the camera view etc
**Restarted the aircraft about 20 times with the same result. 83% and stalled
**Installed Assistant 2 on a Macbook Pro and it recognized the aircraft and I started the latest 0200 update, it stalled on 76% complete every time.
** Connected the RC to Assistant 2 and successfully updated to 0100
** Installed Assistant 2 on a Window 10 machine and it recognized the aircraft and I started the latest 0200 update, it stalled on 76% complete every time. Of note - Windows 10 would NOT recognize the RC
** Using Assistant 2 on the Macbook I restored the factory settings of the Aircraft and then tried to run the 0200 firmware update again. Same result. Difference this time is that now the go4 will not start the firmware update and errors out saying its not connected to the aircraft (despite green lights flashing on RC and Aircraft and being able to enter camera view) - Also I can no longer launch the aircraft as it now says it must be updated first.
** Installed a micro SD card - Sandisk Extreme 64GB. This was recommended by DJI support on chat. No change. It did seems to error out a bit quicker after this, instead of hanging on the 76% screen for ages. It errored out and did display a 100% graphic. I'll upload the screen cap I took when I get home.
So I'm at a stand still now - and DJI support still has not replied to my ticket, except for the initially contact 2 days ago where they asked for my details, proof of purchase, serial number etc.
Thanks heaps for the question, and many thanks for looking at my issue. Really appreciate all the help from everyone! |
|