Hi,

I have a phantom 2 with the following components installed:

1. iosd mini

2. AVL58 Tx and Rx (for FPV kit)

3. H3-2D gimbal

4. gopro 3+ (silver edition)

Everything works fine until I connect up the monitor for FPV. I receive the iosd data on the monitor but no video signal.

I have checked:

1. Tx and Rx for green lights and on same channel

2. Wiring connection3. gopro and monitor are both on PAL

4. gopro firmware has been updated to the latest firmware

Any hints or tips for something that I'm missing?

Thanks

You might want to check the connection at the GoPro camera, where it plugs in on the side of the camera.  Make sure the wire ribbon is secured to the connector that plugs in.  Check the wire ribbon for damage.

I. P. Freely Posted at 2015-5-4 21:54
You might want to check the connection at the GoPro camera, where it plugs in on the side of the cam ...

It plugs in from behind - it doesnt use the mirco USB connector on the side, but thanks for the tip!