alexeyzhukov
New
Russia
Offline
|
S1000+A2+Z15+LB
So everything worked pretty nice despite no video link to my android, all the firmwares on A2 and LB were up to date. Triple checked all the wires. The only chance was to update Z15 GCU.And so it's began. After updating both GCU and IMU and power cycling the device, gimbal went nuts. It kept turning from side by side in the Y axis up to the limit with serious impact, then freeze in one position trying to burn motors and starts this self destructing procedure again when touched.
The assistant software (How came there's no mac version?) shows now that it is BMPCC. Tried to refresh the firmware, no good. Unplugged the Z15 connector from GCU and updated, no good. Have found a couple of guys with same exact problems
but unfortunately no solution.
Replacing the GCU/contacting the dealer seems to be an option, but it means time and money and sounds like "We dont give a **** about your problem"
Any chance to downgrade? Any developer mode?
|
|