Hi,

Simple question on channel mapping. Where should it be done, there are basically two options. When I plug into A2 so doing it in Assistant OR in the Lightbridge (1). main unit? I think it's possible to do either on them? but in which should it be done? I would imagine that it doesnt matter but I think they mixed up somehow last time.. now I got new gimbal and want to do it correctly.

Thanks for help!
Madis

This link may help: http://dl.djicdn.com/downloads/l ... art_Guide_v1.06.pdf

Here is a section that refers to both the Lightbridge and the A 2 Controller:

DJI-Mark Posted at 2018-3-22 13:40
This link may help: http://dl.djicdn.com/downloads/lightbridge/Lightbridge_Quick_Start_Guide_v1.06.pdf

Here is a section that refers to both the Lightbridge and the A 2 Controller:

I have read the manual first. It tells how to set up the system (cables and so on). and also tells that on each ground unit you can map 8 channels and air unit 16 channels. Anywhere doesnt it say should you map anything on A2 assistant itself? or does it matter on which you map it.

With old gimbal, i  remember that the mappings on each other didnt "sync" and I had little issues with it. So just wanted to make sure this time how it should be done. Didnt fly ower winter so don't remember any more how it was.