If i set the Return to Home Altitude and close the App and start again it is by 0m Why ?
The Phantom 3 and  the remote controll is on !

Can someone Help me ?

It defaults to 20m.  Right now this a glitch in the App.

Ok. Thanks

if i set the Altitude and don´t close the App it will take this Altitude ?

Tahoe_Ed Posted at 2015-5-7 09:56
It defaults to 20m.  Right now this a glitch in the App.

Is it just showing zero but will still go to the altitude you set or is it being saved as zero too?

it save it first but if you close the app than it is back on 0m.

martinfluegel Posted at 2015-5-7 10:06
it save it first but if you close the app than it is back on 0m.

So if it crashes we're screwed?

I was researching this very same thing myself.  Flew first flight and noticed this.  I tested return to home at low altitude near home location and it worked fine.  My worry is that return to home at higher altitude will cause it to run into tree/etc. if it depends to fast.  I read manuals and can't find anything to clarify.  On Phantom 2 Vision + I had it set at 125' and that worked great.  

smittyvette@hot Posted at 2015-5-7 10:38
I was researching this very same thing myself.  Flew first flight and noticed this.  I tested return ...

decends.....damn spell check

Tahoe_Ed Posted at 2015-5-7 09:56
It defaults to 20m.  Right now this a glitch in the App.

Is this being corrected?

smittyvette@hot Posted at 2015-5-7 10:44
Is this being corrected?

DJI is aware of this and is addressing it.

iOS bug. As Ed said above, R&D already know it. And it's just a UI bug, the height info is already saved, won't effect the RTH process.