Marsofearth
lvl.2
Flight distance : 89829 ft
Canada
Offline
|
DJI Diana Posted at 2018-3-30 23:10
Hi, thank you for the information, please make sure all the firmware of the drone, remote controller, batteries and DJI GO4 app are the latest one, I still recommend you to try the update again, then change another open area where the GPS is good, no magnetic interference, no big wind, to try the flying again. If there is any further issue, please feel free to let us know and provide a photo of the error message if applicable, we can look into it. Thank you in advance!
https://www.youtube.com/watch?v=XPmWvxeSp7E&t=0s&list=PL8-vxWY64sBOeP6CJM0vmkDB0onco2V2i&index=7
1. ...please make sure all the firmware of the drone, remote controller, batteries and DJI GO4 app are the latest one...
How do I update the battery firmware?
I have tried all three batteries, all fully charged.
2. I still recommend you to try the update again...
Okay, I will try again. This would make the 4th refresh of firmware on the drone and 3rd on the controller.
3. ..change another open area where the GPS is good, no magnetic interference, no big wind, to try the flying again..
The last two spots were very open, very good gps, out in the countryside with no magnetic interference. It is spring here, so the chances of flying without any wind is 0%. Average wind speeds of 5-10km/h. I have flown several times in 20-30km/h winds on our mountain with no issues before. I have been incredibly impressed with the mavic air's ability to remain steady.
I will try and find a place that meets all this criteria though. And test under near perfect conditions.
3. provide a photo of the error message.
I really do not feel comfortable flying the drone in this unstable state. What if it glitches, and I lose it?
I will borrow another person's phone and try and take a photo or movie.
4. Down sensors dirty?
All sensors are very clean. I have also run through the sensor calibration twice on my computer.
5. Sticks, grass, or dirt in the motors? Do motors turn freely.
All very clean, motors turn freely like new.
6. One of the sensitivity settings turned way up?
I reset everything on my controller to factory settings, however I will inspect all the sensitivity settings.
I'll have one more go with the drone. One more full refresh of firmware, (drone, controller, software), check all the sensitivity settings on controller app, and try and find an absolutely perfect flying condition location.
I'll report back.
|
|