I have a Naza-m lite, Recently problem occurred and when the quadcopter in gps mode he wont hover in point but drifting, and sometimes the quadcopter turn upside down when i hoverd and push the ELV stick.
The gps satelites LED are good (Shows GPS locked).
Sorry I think there is not enough information to allow people to give advice.
Many issues could cause this.
Check all you motor esc connections. Check props and motor directions for each arm. Make sure the prop is on correctly and the motor is spinning in the correct direction for each arm
Make sure motors are plugged into correct ports on the Naza.
Make sure with the Assistant software that you are in the correct flight mode.
Make sure compass is calibrated.
...... Check our whole setup and post information to help us troubleshoot.
Hi Joe,
All the motors, escs,props connections and directions are good, if not the quad wont be able to fly,,
in my case the quad are flying but drifting away in gps mode.
The flight mode are correct(I check in the Assisant softwer) and i do compass calibrate.
In GPS mode the LED is one green and 3 flashes red (means i do get satellites).
Thanks, Daniel.
Three red flashes means you do not have enough satellites.
Preferably you should have no red flashes which means you have good GPS status.
I never fly with any red flashes.
I you are trying to fly with 3 red flashes you will not have a good GPS lock and copter most likely will drift.
If you cannot get to zero red flashes then you have a issue with GPS at your location or you have a hardware issue.
Hey!!
I recently bought Naza m lite with M8N GPS.
I had good satellite connection with no red blinking but then also the quad was drifting and sometimes loosing the altitude.
I turned the Failsafe on the quadcopter returned to home but as soon as it returned it drifted so badly and had a crash.
Is it due to the magnetic declination or there are some other factors.
my all ESC's are calibrated.
please help soon as possible.
lvl.1
lvl.3
New