Please select Into the mobile phone version | Continue to access the computer ver.
Circuit board protection
643 5 2018-4-6
Uploading and Loding Picture ...(0/1)
o(^-^)o
lannes
Captain
Flight distance : 4465 ft
  • >>>
Australia
Offline

Does anyone now if DJI use conformal coating on it's circuit boards ?

Flying in salty sea air would cause corrosion over time if the circuit boards were not in some way protected.
Sea air is sticky and a fine layer of salt gets deposited on all surfaces it comes into contact with.
2018-4-6
Use props
DJI Diana
Administrator
Flight distance : 2408 ft

Offline

Hi lannes, it is not recommended to fly the drone in a harsh environment. Please take good care of the drone and fly in the normal open area. Thanks!
2018-4-6
Use props
HedgeTrimmer
Captain
United States
Offline

I would hope they do.  Being their products are used primarily outside.
2018-4-6
Use props
lannes
Captain
Flight distance : 4465 ft
  • >>>
Australia
Offline

DJI Diana Posted at 2018-4-6 22:09
Hi lannes, it is not recommended to fly the drone in a harsh environment. Please take good care of the drone and fly in the normal open area. Thanks!

Hi Diana

Thanks for your reply can you give us an example of a harsh environment ?
2018-4-6
Use props
DJI Diana
Administrator
Flight distance : 2408 ft

Offline

Hi, kindly please check this video: , section two, choose a safe flight environment. It is not recommended to fly a drone in the salty sea air, thanks!
2018-4-7
Use props
Buzzyone
Captain
Flight distance : 2258251 ft
  • >>>
Offline

They seem to use a brushed on con coat, you should be ok, a wipe down with a damp cloth will be all that’s needed, the air is pushed through the heat sink and exhausts out the rear, there is a small airflow over the flight controller/esc pcb which is well con coated.
2018-4-8
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules