After a few flights I started having compass calibration issues. Aircraft would not fly. After many attempts at calibration I finally replaced compass. Compass problem solved however aircraft will not take off. Props shudder. I turned aircraft off and now I cannot get aircraft to power up. Battery shuts down after few seconds. Any ideas?

Do you have another battery?

Not sure what else to suggest.


Check the battery contacts, in the aircraft as well.


RedHotPoker

Fire battery on out side the AC and look what is the reaction of the LEDs and then switch it off and do it again inside the AC. You may have a look on to the contacts as RedHotPoker mentioned.

Hi there, it is recommended changing to another working battery to see whether the drone can be powered on or not. If yes, please check whether there is any error message in APP to guide the further steps.

I have three batteries none will power up aircraft. Battery contacts look fine.

Did you check the board for damage while installing the new compass?

I inspected not sure what to look for

MPA Posted at 2018-4-9 05:36
I inspected not sure what to look for

Sending to DJI for repair

MPA Posted at 2018-4-9 19:12
Sending to DJI for repair

Sorry about this. Please kindly start a case and send it in from here: https://www.dji.com/support

Did you happen to have any of the props, prior to the compass failure issue , smack any branches or anything where the props are stopped while motors are running? Sounds like it could be the ECS board. Good luck.

No. But thanks for reply.