Is there any way you get or order the Rubber Cap for P4Pro+ that covers the charging port?

Please need Help!

Is there any way you get or order the Rubber Cap for P4Pro+ that covers the charging port?

Please need Help!

It's not important.  If you've lost one don't worry about it.

Just put a little tape over it.

Fill it full of glue or cement.
That will keep the dust and water out.

Gonna have a hard time when charging with all that glue lol.

It just a problem when you sell to some of the picky buyer, it should be a free part from DJI, it is a know problem.

I need the Rubber cap that goes on any P4 RC, to replace the broken one I have, how do I get a replacement cap?
It makes it harder to sell to a picker buyer, If one of the Administrator could help, DJI MINDY are you around.
Thanks, a head of time, Mindy.......

Could you have one 3D printed?


RedHotPoker

If you had a good one to start with, may cost more than it worth.
Thanks, for your input.

Dog Man Posted at 2018-4-9 08:36
If you had a good one to start with, may cost more than it worth.
Thanks, for your input.

With all of the faulty parts replaced, including RC there must be hundreds if not thousands of them, spare...

Perhaps one of the forum mods, that work in the vicinity of the NA warehouse, could swangle you one.


RedHotPoker

Did you do like me, and rip it off putting it in the Styrofoam case? I put it back in place after charging and it stays there all happy. Haven't lost it yet...

Jeff

I also have this question

No, just brought that way.....

Sorry, that ME

Hi there, please try to contact the support to see whether they can help: https://www.dji.com/support
Also, please do not start multiple posts with the similar topic at the same time, we will check and merge the duplicate ones. Thanks for your cooperation.

Thanks, will check.......