Added patch antenna detection. When connected, the Cendence LCD screen will always display “Patch antenna connected.” When disconnected, the LCD will display “Patch antenna not detected” for a short time (approx. 10 seconds). Cendence will emit a sound at the moment of patch antenna connecting and disconnecting.
Optimized the Focus Adjustment Knob (TD) control to fix an issue where focus adjustment range would be limited when used with some types of lens.
Optimized control over adjusting the camera exposure parameters. Rotate the dial clockwise to increase the exposure and counter-clockwise to decrease it.
Fixed an issue where the right dial would not set the camera parameters when using the Inspire 2 standard remote controller as the slave controller and Cendence as the master controller.
Fixed an issue where the LCD would display “System error” when Cendence had a low battery level.
If using the Inspire 2 standard remote controller as the slave controller, it must have firmware version v1.1.0010 or later.
My DJI Patch Antenna - although detected after recent Cendence FW update - doesn't perform as expected. Flight distance of my M200 is about 1 km before transmission is falling apart, while with standard stick antennas I can fly 2.5-3 km away. I'm aware of particular positioning of patch antenna ... Should I return faulty product and demand replacement?