After a safe flight one afternoon, I turned off and packed away the phantom and monitor into their respective Pelican Cases.  Upon my return to home, i turn on the Phantom2, remote, and monitor...then to my suprise, this happens to my video. I have since replaced the video transmitter (ImmersionRC 600mW 5.8Ghz) and associated antenna, and still, the display remains the same.  When I plug the GoPro Hero3+ into the pc, the video appears fine, so I'm positive it's not the camera.  All other flight controls function properly, as well as gimbal control.  I have also verified the channel and frequency settings and matched the transmitter to reciever (band F ch 6).  I tested all the other channels as well and the problem follows.  Has anyone else run into this?  Any help would be GREATLY appreciated!  

Specs:
Phantom 2
Stock Controller
iOSD mini
ImmersionRC 600mW 5.8Ghz A/V Transmitter
FlySight 7" Wireless Monitor
Using 3 Dipole antennas (1x video transmitter, 2x on monitor)

After a safe flight one afternoon, I turned off and packed away the phantom and monitor into their respective Pelican Cases.  Upon my return to home, i turn on the Phantom2, remote, and monitor...then to my suprise, this happens to my video. I have since replaced the video transmitter (ImmersionRC 600mW 5.8Ghz) and associated antenna, and still, the display remains the same.  When I plug the GoPro Hero3+ into the pc, the video appears fine, so I'm positive it's not the camera.  All other flight controls function properly, as well as gimbal control.  I have also verified the channel and frequency settings and matched the transmitter to reciever (band F ch 6).  I tested all the other channels as well and the problem follows.  Has anyone else run into this?  Any help would be GREATLY appreciated!  

Specs:
Phantom 2
Stock Controller
iOSD mini
ImmersionRC 600mW 5.8Ghz A/V Transmitter
FlySight 7" Wireless Monitor
Using 3 Dipole antennas (1x video transmitter, 2x on monitor)