Hi;

I have noticed that sometimes when i switch on the MP, the bar on top will switch between OPTI mode and GPS mode and back again... This is despite the GPS bars showing 12 or more sats.

Ocassionally it will stay stuck like in the pics below.. GPS mode at the bar and OPTI mode in the menu at the same time.. it goes away if i close the app and restart it.

Perhaps it is just a UI refresh error. I have not had any issues with it so far but I would rather not fly with an unknown mode.

Anyone with similar issues?

Hi, please check the user manual of the Mavic pro: https://dl.djicdn.com/downloads/ ... 0Manual%20V2.0-.pdf, you can know more information about the flight mode, as the picture below shows. Thanks.

Thanks Diana. I understand the modes thats used in the MP.

Its just that the controller shows OPTI mode and GPS mode at the same time. Is this supposed to be the case?

Jay W Posted at 2018-4-25 04:15
Thanks Diana. I understand the modes thats used in the MP.

Its just that the controller shows OPTI mode and GPS mode at the same time. Is this supposed to be the case?

This is the reason. The sensor are warning you.

G_Sig Posted at 2018-4-25 10:58
This is the reason. The sensor are warning you.
[view_image]

Ok.. Thanks. I will test that again with some daylight tomorrow.

Jay W Posted at 2018-4-25 13:29
Ok.. Thanks. I will test that again with some daylight tomorrow.

You can set the drone to the same place and try to turn Obstacle Sensors off and see what happen.
If you see red marks on the radar it will do this.