akAir
United States
Offline
|
Mobile: Samsung Galaxy S7 Edge.
I have a new Air that was working fine. I've only flown two days but was very impressed and flew with this phone out to 2500ft and back no problems. Now I am sitting in my house on a rainy day and just wanted to go through some of the gimbal and camera settings for future flights. I was connected and had adjusted gimbal speed and had been making adjustments to the camera settings in manual and was goign to make adjustments to the sensitivity etc., and then lost connection to the AC which was perhaps .5 meters away from me.
Since then I've gone through various methods of connecting. In one case the app shows looking for update and then I get the Go Fly but just as fast it starts to check for updates again and the app shows disconneted from the AC.
I have tried to enter device via wired connection and when I click through the screens on the app I keep getting a popup that says "Sorry, this video cannot be played." What? I had never seen that before and I'm not selecting any video!
Keep in mind, the RC light is green and the AC light is flashing green, but app says not connected.
So now I can try via camera only mode. I tell it to search for freqs and the RC beeps and flashes red, the AC function led starts flashing fast yellow. I push the function button until it beeps, and then the RC and AC link, green lights. Good. Except the app still says the AC is disconnected.
Why would it connect for only a few seconds sitting right next to me and then disconnect? Why does the RC show green and AC function led flash green yet app in camera mode says disconnected?
|
|