Hi,

Im having problems trying to get this working.

Is it possible to have LB connected to A2 and a GH3 gimbal?

Is my connections correct? A2 X2 port to DBus on LB.  GH3 gimbal is only connected via Can bus into a can hub(im using IOSD mk2 for this purpose)

Canbus for LB, Canbus for GH3 gimbal and GPS puck Canbus into an IOSD mk2 operating as a can hub.

is this setup possible? im having issues controlling it from my TX. i've set the T14SG to 12 channels on trainer port. managed to map my pan, tilt and camera modes on the switches and knobs. unable to see change with my controls.

im setup in a single operator mode all controlling from my T14SG.

Hi, the attached connection for your reference

After connection, don't forget to map the channel in A2 assistant,D1-D4.

DJI support 8 Posted at 2015-5-11 15:07
Hi, the attached connection for your reference

After connection, don't forget to map the channel i ...

Hi,

with this setup, do i still need to configure the rest of the channels with lightbridge assistant or with A2 assistant? since controls is with lightbridge?

nicholashon19@g Posted at 2015-5-11 22:10
Hi,

with this setup, do i still need to configure the rest of the channels with lightbridge assis ...

configure in LB assistant first, and then in A2 assistant
You can find more information in the link below
http://www.dji.com/product/dji-lightbridge/download