hello everyone....i hav 2.4 data telemetry connected to A2 flight controller. the ground end resets itself when the hexarotor goes out of range..since the ground end data telemetry restarts , the com port disappears for a second and reappears on the device manager.when the bird comes inside the range again, the GS doesnt display the telemetry data..in order to get the data we hav to disconnect the com port on GS and reconnect again....does this thing happens with ipad ground stations?how should the ground end of 2.4 data telemetry should response when its link with the air end is disconnected? does ur ground end data telemetry restarts?...the indication of ground end telemetry resetting is that we get two times red blinks on both the link n tx/rx led...anybody having any solution for it?

hello everyone....i hav 2.4 data telemetry connected to A2 flight controller. the ground end resets itself when the hexarotor goes out of range..since the ground end data telemetry restarts , the com port disappears for a second and reappears on the device manager.when the bird comes inside the range again, the GS doesnt display the telemetry data..in order to get the data we hav to disconnect the com port on GS and reconnect again....does this thing happens with ipad ground stations?how should the ground end of 2.4 data telemetry should response when its link with the air end is disconnected? does ur ground end data telemetry restarts?...the indication of ground end telemetry resetting is that we get two times red blinks on both the link n tx/rx led...anybody having any solution for it?