see duration from 0:26 (min:sec) to 0:30 (min:sec)
and
duration from 0:48 (min:sec) to 0:58 (min:sec)
I have checked the firmwares. All firmwares of my drone Phantom FC40 are up to date, but when I connect Zenmuse module which is hidden inside the drone IMU module was out of date. My firmware was 1.4 and I upgraded it into 1.10. GCU was ok and it was 1.8 version so it was actual.
Can you tell me if GCU could cause the shaking problem with my video?
After upgrading firmware of IMU from 1.4 into 1.10 I have noticed that my drone was working ok (without shaking).
But the 2nd flight was not ok. My gimbal was completely out of use. Go Pro video camera looks like it was not on any gimbal. The picture was upside down. After a few hours after charing battery I have checked only gimbal if it react on moving on x,y,z dimensions. It was working ok. But I still don`t know why my 2nd flight was so unpredictible. Take a look at this movie: